Open the Arduino preferences and turn on the checkbox to enable verbose output during compilation. Launch your installed version of Arduino and choose Teensylu/Printrboard from the Tools Board menu.
#Mac os 8.6 open firmware user manual software#
ĭownload the pre-configured Arduino software from the link available at and copy it to your /Applications folder. See the following sections for more detailed instructions.ĭownload a pre-configured Arduino build environment that contains the compilers for the AT90USB1286 chip from. The source code used to build the factory-default firmware as well as checksum information for the provided hex files is available at Advanced users may wish to compile their own firmware either to adjust some configuration parameters or to experiment with new features. You can use the files above to restore to a factory-default state. Obtaining a firmware fileThe default firmware as shipped is archived at įor the Printrbot Junior ONLY the shipped firmware is Please follow all steps in this guide carefully and, above all, try to understand what they do so that you are comfortable with backing out of any errors. While the procedure is well tested there is a small possibility that you could irreparably damage your printrboard. Updating new firmware is recommended only for intermediate to advanced users. The printrbot ships with Marlin 1.0 RC2 installed and that is the version that the printrbot team currently recommends. What is firmware?Firmware is the software that runs directly on the printrboard which interprets the GCODE and converts it into signals to the various motors on your printrbot.
0 kommentar(er)
